Diamond ATLANTIS TM69 LED Manual De Usuario página 38

PROGRAMMING SYSTEM TM69 LCD
6. OTHER INITIAL CONFIGURATIONS
Setting parameters
Mode:
Valve model:
Control type:
Resin volume:
Filling volume:
Interval time
regeneration:
Backwash time:
Suction time and
slow washing:
Filling time:
Washing time
Quick:
These adjustments are already made in the factory.
All parameters are for reference only. The most
suitable time for regeneration, backwashing and
rinsing depends on the quality of the resin. Check
with your dealer or customer service if you need to
reset the valve.
User mode
After connecting the equipment to the electrical
network, the interface of the valve will be displayed
for 3 seconds and then the system will enter user
mode.
Decalcifier process screen
Service status 1
Factory settings
AT6927
Descaling
TM69 LCD
Meter type (adjustable)
25 L
Countercurrent
40 days
12 min
60 min
4 min
12 min
Service status 2
Backwash
Refill
Motor Running
Working process: Service -> Backwashing ->
Aspiration and slow washing -> filling -> fast
washing -> Service (repeat cycle).
Introduction of the brine valve
In the brine and slow rinse state, with the float
switch, the brine valve can prevent air from being
inhaled, which can affect the regeneration and
normal operation of this system. That is, the brine
valve has the function of air control.
In the brine fill state, the brine valve can control the
water fill volume by controlling the position of the
float switch.
Introduction of the by-pass valve
When the piston is pushed to the inlet and outlet
position, the valve is in the service state. When in
the bypass position, the valve is in the bypass state
and water does not pass through the control valve.
The control valve and bypass valve have a quick-fit
design, are perfectly sealed and are easy to install
(Please see the images below).
Test operation
After installing the water softener and configuring
the relevant parameters, perform a functional test.
The procedures are the following:
12
EN
Upflow and rinse
Fast rinse