Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMING SYSTEM TM69 LCD
·
Add salt to more than 2/3 of the height of the
softener and manually add enough water to
dissolve all the salt to obtain a saturated brine
solution (26%).
· 25 L model: 9 liters of water.
·
Connect and press
mode. Open the inlet valve slowly up to 1/4" from
the fully open position (DO NOT open the inlet
valve too quickly, otherwise the appliance could
be damaged and the resin could come out) to let
all the air out of the FRP tank .
The user will hear a sound from the air outlet of
the drain pipe during this process. Once all the
air has gone out, completely open the inlet valve
and activate the backwash for 2-3 minutes to
empty the resin and drain the impurities and
broken resin granules.
·
Press
to end the backwash mode. Put the
valve in suction and slow wash mode. In this
state, the brine solution will enter the FRP resin
tank for resin regeneration. After that, the valve
closes and a 15 minute slow wash begins which
removes the replacement brine solution. The
complete process of aspiration and slow
washing takes approximately 40 minutes.
·
Press
to end the vacuum and slow wash
mode. Put the valve in "fill" mode to add more
water and dissolve the salt. When the time is up
or the water level reaches the height in the initial
configuration, this state ends.
to start the backwash
·
Press
to end the "fill" mode. Set the control
valve to the "fast wash" state to remove the
remaining brine solution in the FRP tank and
compact the resin to achieve the best decalcifier
performance. This process takes about 7
minutes.
Press
to end the quick wash mode. Return the
·
valve to service mode to continue.
13
EN
Publicidad
Tabla de contenido
