BH YF95 Manual Del Usuario página 5

FITTING THE BATTERIES.-
This monitor
ALKALINE BATTERIES.
To fit the batteries, remove the rear
cover on the monitor, Fig.1, and
carefully insert the two "R-6" type
batteries into the battery compartment
(A) making sure that the battery's
polarity is correct
battery's «+» terminal with the «+»
sign inside the battery compartment,
and the «-» terminal with the «-» sign).
Close the cover, as shown in Fig.1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important:
components in special containers Fig.2.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous read-outs
distance, exercise time, calories burnt
and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes.
A. SCAN FUNCTION.-
In SCAN mode
continuously scans and displays all of
the functions during exercise. The
uses two 1.5
(matching
Deposit electronic
of speed,
the computer
English
function being displayed will flash on
and off.
volt
To select the SCAN function:
1. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
CALORIES, values every 8
the
2. Press the key and this will cancel
the SCAN function.
B. TIME FUNCTION.-
This function counts up in steps of one
second, up to a maximum of 99:00
seconds.
Pressing the key for more than two
seconds will reset all of the values.
C. DISTANCE FUNCTION.-
This function counts up or down in
steps of 0.01 km/ml, up to a maximum
of 99.99 km/ml.
Pressing the key for more than two
seconds will reset all of the values.
D. CALORIE FUNCTION.-
This function counts up in steps of 0.1
calories, up to a maximum of 999.9
calories.
Pressing the key for more than two
seconds will reset all of the values.
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function works
Solution:
a.- Make sure that the connection
cable is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
5
seconds.