GET 2ND INJ. KIT Guia De Instalacion página 4

7. Mark on the airbox the Ø 11 mm / 0.43" hole for the second
injector harness as shown. Mill the hole.
FUEL HOSES
1. Remove the OEM fuel hose from the motorbike.
2. Cut the OEM fuel hose to the following measures (do not
consider fuel couplings in the measure):
A (Fuel pump side) = 110 mm / 4.33"
B (OEM injector side) = 100 mm / 3.94"
110 mm / 4.33"
To the fuel pump
A
3. Remove the ends of the
three-way fitting on all three
outlets to make the following
fuel hoses installation on the
3-way fitting easier.
4. Connect the A and B hoses
to the 3-way fitting and fix
everything with the Ø12 mm /
0.47" hose clamps provided.
EN
100 mm / 3.94"
To OEM injector
B
A B
6
D. 2ND INJECTOR KIT INSTALLATION
2ND INJECTOR ASSEMBLY
1.
Proceed with the
assembly as shown:
place the seal provided
in the kit inside the 2nd
injector support inner
bracket's hole. Use the
two spacers, the screws,
the washers and the nuts
included in the kit to fix
the injector and the fuel
rail to the 2nd injector
support inner bracket.
We suggest applying
a strong threadlocker
(e.g. Loctite 278).
2.
Connect one end of
GET fuel hose to the fuel
rail using one of the Ø13
mm / 0.51" hose clamps
provided.
GET
Fuel hose
7 EN