GET 2ND INJ. KIT Guia De Instalacion página 6

2ND INJECTOR KIT INSTALLATION
1.
Reposition the air filter support in mesh and the air filter.
2.
Re-install the airbox, now equipped with GET second
injector, on the rear subframe. Fix the lower air filter to the
airbox. Put the rear subframe back in the original position
and tighten the air filter connecting tube's clamp to fix the
manifold to the airbox.
3.
Re-install the motorcycle's main wiring support clip
to the airbox. Re-install the breather tube. Connect the
air temperature sensor and the starter relay.
4.
Connect GET ECU
and the relay to the
motorcycle's main
wiring. Re-install the
control unit lid.
5.
Re-install the rear fender and the exhaust pipe.
6.
Connect GET fuel
hose to the 3-way fitting
and fix it with a Ø13 mm
/ 0.51" hose clamp.
EN
GET
Fuel hose
10
7.
Connect the end of
hose "B" to the OEM
injector.
8.
Connect the end
of hose "A" to the fuel
pump. Re-install and fix
the fuel tank.
9.
Remove the
protective cap from
the "INJ2" GET ECU
connector and plug it
into the female second
injector harness
connector.
Place side
by side GET second
injector harness and
the OEM main wiring of
the motorcycle and fix
them with zip ties (not
included).
10.
Fix the voltage regulator with the two OEM screws.
Re-install the exhaust pipe, the plastics and the seat. Re-
connect the battery and install the battery lid.
11
B
To OEM injector
A
To the fuel pump
Second
GET
injector
harness ECU
EN