Troubleshooting - Sub-Zero Designer Serie Guía De Uso Y Mantenimiento

Troubleshooting

Troubleshooting
UNIT OPERATION
No lights or cooling.
Verify power is on.
1
2 Verify electrical power to the unit and home circuit
breaker is on.
No lights.
1 The door may have been left ajar, which has disabled
lights to eliminate excess heat. If the lights are out,
close the door for one hour. If the lights are still out,
contact Sub-Zero Factory Certified Service.
2 LED interior lighting must be replaced by Sub-Zero
Factory Certified Service.
Condensation forms inside the unit.
Verify the condenser is clean.
1
2 Verify the door is closing properly.
3 Verify the door has not been left ajar.
Verify the door gasket does not have rips or tears.
4
If it does, contact Sub-Zero Factory Certified Service.
High temperatures, the unit runs excessively, or the unit
is giving off too much heat.
1 Verify the condenser is clean.
Verify the door is closing properly.
2
3 Verify the door has not been left ajar.
4 Increased ambient temperatures may cause the
compressor to run longer.
If the temperature display shows 13°C and 7°C, but is
5
not cooling, the unit may be in Showroom Mode.
Contact Sub-Zero Customer Care at 800-222-7820.
ODOR
Clean the unit before using for the first time. This will
1
clear any odors that may have been trapped during
shipping.
SERVICE
• Maintain the quality built into your product by contact-
ing Sub-Zero Factory Certified Service.
• When contacting service, you will need the model and
serial number of your unit. Both numbers are listed on
the product rating plate. Refer to page 6 for rating plate
location.
• For warranty purposes, you will also need the date
of installation and name of your authorized Sub-Zero
dealer. This information should be recorded on page 2
of this guide.
SERVICE (FOR AUSTRALIA ONLY)
• Yearly maintenance is recommended.
•
Maintain the quality built into your product by contact-
ing Sub-Zero Factory Certified Service.
• When contacting service, you will need the model and
serial number of your product. Both numbers are listed
on the product rating plate. Refer to page 6 for rating
plate location.
•
For warranty purposes, you will also need the date of
installation and name of your authorized Sub-Zero
dealer. This information should be recorded on page 2.
• For Australia only, contact:
Sub-Zero Group Australia Pty Ltd
Level 10, 469 La Trobe Street
Melbourne Victoria 3000
Phone 03 9600 2218
subzero-wolf.com.au
SERVICE (FOR UNITED KINGDOM ONLY)
• Sub-Zero & Wolf Ltd
9 The Street, Heybridge, Maldon, Essex, CM9 4XB
020 8418 3800
service@subzero-wolf.co.uk
www.subzero-wolf.co.uk
subzero.com | 9