Before First Use - Hilti PS 250 Manual De Instrucciones

The completed Imagescan is shown shaded.
5 6 7
150 300
1
150
2
300
3
450
4
600
Select the next Imagescan position and repeat the scanning procedure. Imagescans already made may be repeated
simply by reselecting the area to scan and carrying out the Imagescan again. The data will be overwritten. Once all the
Imagescans have been recorded, or the maximum number of scans that can be held in memory is reached (9), press
the Cancel button to return to the main menu. Transfer the data to the monitor for viewing and analysis ( see 7.4.1).
NOTE
Pressing the Cancel button twice causes the recorded Imagescan to be deleted. The screen then returns to the main
menu.
7.3 PSA 55 infrared adapter

7.3.1 Before first use

NOTE
Install the Hilti PROFIS Ferroscan 5.7 software (or a higher
version) on your PC/laptop. The date and time must be
set before using the PSA 55 IR adapter for the first time
in order to ensure that the scan data subsequently shows
the correct date and time.
To do this, use the PUA 95 Micro USB cable to
connect the PSA 55 IR adapter to the computer.
Start the Hilti PROFIS Ferroscan application.
Go to "Tools", "Workflow" and then select "Set PSA
55 date and time".
The date and time are then set in the PSA 55 IR
adapter.
8 5 6
450 600 150 300
1
150
2
300
3
450
4
600
7 8
450 600
NOTE
The device driver is installed together with the Hilti
PROFIS Ferroscan (V 5.7) software. If this is not the
case, the device driver must be installed manually by
running the "setup.exe" file located in the "Drivers" folder
on the PSA 55 IR adapter.
7.3.2 Operating the PSA 55 infrared adapter
The scans can be transferred to the adapter via the
infrared interface and from there to the PC/laptop.
Switch the adapter on or off by pressing the on / off
button for about 3 seconds.
The LED display on the adapter can indicate the following
statuses:
en
25