Items Supplied, Accessories, Spare Parts - Hilti PS 250 Manual De Instrucciones

2.6 Quickscan detection with accurate depth measurement
Before scanning, the operator is required to enter values for the diameter of the reinforcing bars and the spacing
between the bars. The scan is then carried out as described for Quickscan detection.
2.7 Quickscan recording
Data is recorded automatically as the scanner is moved over the surface of the concrete. This data is subsequently
transferred to the monitor where it can be evaluated and the average depth of cover determined. If the data is
downloaded to a PC, the information can be evaluated, archived and a report printed. Further evaluation options
allow Quickscan recordings to be imported and evaluated automatically, statistical evaluations prepared and scans
displayed in the form of large-area evaluations.
2.8 Imagescan
A reference grid is attached at the area of interest using the adhesive tape supplied. After selecting the Imagescan
mode with the scanner, the rows and columns of the grid are scanned following the instructions on the screen. The
data is transferred to the monitor where the image can be viewed and evaluated. The position of the reinforcing bars
relative to the concrete surface is indicated. Bar diameter can be estimated and bar depth determined. If the data is
downloaded to the PC application, this information can be evaluated as on the monitor, with the additional advantage
of allowing a series of points to be recorded along with associated depth and diameter, and the data saved for
future use. Reports can also be printed. Further evaluation options allow Imagescans to be imported and evaluated
automatically, statistical evaluations prepared and scans displayed in the form of large-area evaluations.
2.9 Blockscan
A reference grid is attached at the area of interest using the adhesive tape supplied. After selecting Blockscan mode,
the user is prompted to select the first area to scan. An Imagescan is then made. After completing the Imagescan, the
user is prompted to select the next area to scan. This should be adjacent to the previous area. Attach the grid and then
scan as before. This procedure can be repeated for up to 3 x 3 Imagescans. The data is transferred to the monitor. The
Imagescans are automatically stitched together to form a larger image. The reinforcement layout can then be viewed
over the whole area. Individual Imagescans can be selected for evaluation by "zooming in". If the data is downloaded
to the PC application, this information can be evaluated as on the monitor, with the additional advantage of allowing a
series of points to be recorded along with associated depth and diameter, and the data saved for future use. Reports
can also be printed.

3 Items supplied, accessories, spare parts

3.1 Items supplied
3.1.1 PS 250 Ferroscan system
Num- Designation
ber
1
PS 200 S scanner
1 PSA 60 soft pouch
1
PSA 100 monitor
1 PSA 64 soft pouch
1 PSA 63 hand strap
1 PSA 55 infrared adapter
1 PUA 95 Micro USB data cable
1 PSA 97 data module
1 Version depends on the country-specific version of the system ordered.
2 May or may not be included in the items supplied, depending on the country-specific version of the system ordered.
Comments
1
Soft pouch for the PS 200 S scanner
1
Soft pouch for the PSA 100 monitor
For the PS 200 S scanner
For temporary storage of data from the PS 200 S scanner
Data cable for connecting the PSA 55 infrared adapter to a PC
Contains the operating instructions in electronic form and is used to
update the PSA 100 monitor
en
3