Troubleshooting - Hilti PS 250 Manual De Instrucciones

tool is operating in accordance with the manufacturer's
specification.

9 Troubleshooting

Message displayed
Symbol appears while us-
ing Quickscan detection
mode.
Symbol appears while
making a Quickscan
recording.
Symbol appears while
making an Imagescan.
Symbol appears.
Fault
The scanner is not record-
ing.
The scanner is not record-
ing.
The scanner is not record-
ing.
The scanner is not record-
ing.
Calibration certificates are always required by companies
certified according to ISO 900x.
Your local Hilti Center or representative will be pleased
to provide further information.
Possible cause
The maximum scanning
speed of 0.5 m/s (1.64
ft/s) has been exceeded.
The maximum scanning
speed of 0.5 m/s (1.64
ft/s) has been exceeded.
The maximum scanning
speed of 0.5 m/s (1.64
ft/s) has been exceeded.
This symbol may appear
if the scanner is moved in
the wrong direction when
in Quickscan record-
ing mode, i.e. you begin
scanning, for example,
from right to left but at
some point during the
Quickscan recording you
move the scanner to the
right.
Remedy
Press the Confirm button
and repeat the scan.
Move the scanner over
the surface more slowly.
Press the Confirm button.
Repeat the scanning op-
eration from the start-
ing point or from the last
point at which a marker
was set.
Move the scanner over
the surface more slowly.
Press the Confirm button.
Scan the row or column
again.
Move the scanner over
the surface more slowly.
Press the Confirm button
and repeat the scan.
Move the scanner in the
correct direction.
NOTE
The warning does not ap-
pear immediately, only
when a movement of 15
cm (6") or more in the
wrong direction occurs.
29
en