Hilti PS 250 Manual De Instrucciones página 26

en
The scanner emits a double beep at the end of the row and automatically stops recording. This procedure should be
repeated for each row and column while observing the instructions shown in the display.
When all rows have been completed, the columns should also be scanned in the same way.
The scanning operation for any row or column may be interrupted before reaching the end by pressing Record again.
This may be necessary if an obstacle prevents the full path being scanned. Similarly, an entire row or column may be
skipped by starting and stopping the recording without running the scanner over the grid.
Please note that no image will be created for areas of the reference grid that are not scanned in both directions.
It is possible to repeat the previous row or column by pressing Cancel. This may be necessary if the user is not
sure whether the path to be scanned has been followed accurately or if the scanner slipped out of position. Pressing
Cancel a second time aborts the scan and the system then returns to the main menu. Press Confirm to save the scan.
Pressing Cancel after scanning the last column or row will cause the scan to be deleted.
When the scan is complete, press the Confirm button to return to the main menu. The data can be transferred to the
monitor for viewing and evaluation ( see 7.4.1).
7.2.7 Blockscan
Blockscan automatically stitches Imagescans together to provide an impression of the reinforcement layout over a
large area. The exact bar position, depth and diameter can also be determined on the monitor by selecting each
Imagescan individually.
23