Fein Slugger JCM 200 QX Instrucciones De Uso página 23

Feed without spoke handle
(JCM 200 auto) (figure 18).
Depending on the application, the feed can
also be actuated from the left-hand side. For
this, apply the drive socket.
To generate feed, turn the drive socket man-
ually while the drill motor is switched on.
Instructions for core drilling.
Do not stop the drill motor during the drill-
ing procedure.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor
and carefully turn the carbide tipped cutter
out counterclockwise.
After each drilling operation, remove the
chips and the slug.
Do not touch the chips with your bare
hand. Always use a chip hook.
Danger of burns! The surface
CAUTION
of the magnet can reach high
temperatures. Do not touch the magnet
with your bare hands.
For core drilling in layered material, use a
suitable Slugger ID cutter.
When changing a cutting tool, pay attention
not to damage the cutting edges.
Fig.18
30 mm/
1 3/16 in
en
23