Safety Instructions - Tecno-gaz TA009TAU Instrucciones De Uso

Safety instructions

1.5
1. Our products are in a flawless condition in terms of safety technology when they
leave the plant.

2. To maintain this condition, the contents of these safety instructions as well as type
plates, labelling and safety instructions attached to the device must be observed
while handling the device (transport, storage, installation, commissioning, operation
and maintenance).
3. This device is suitable for processing laminated films in the heat-sealing process.
See also chapter 2.1 "Intended use".
4. Please check the packaging, and lodge a complaint for any damage with the carrier
or parcel service immediately, before installing the device.
5. Before commissioning, ensure that the device does not show any evidence of
damage. In case of doubt, contact the manufacturer or a service partner authorised
by the manufacturer.
6. Do not operate the device if the power cable or the power plug is damaged. Do not
use the device if it does not operate correctly or it is damaged in any way. If the
mains cable or the device have been damaged, the device must be repaired by the
manufacturer or by one of the manufacturer's authorised service partners.
7. The device must be connected using the mains cable included in the scope of
delivery to a protective contact socket with a stable voltage. Operation on IT
networks is not permitted.
8. Place the device on a stable base.
9. The device must not be installed or operated in potentially explosive areas.
10. If the sealing device is brought directly from a cold environment into a warm
environment, condensation may form. Wait until temperature equalisation has taken
place.
Starting up the device when it contains condensation causes danger to life!
11. Repairs and the replacement of wear parts / spare parts must be performed only by
the manufacturer or by one of the manufacturer's authorised service partners.
12. Switch off the device when it is not in use, or remove the power plug from the socket.
13. Before cleaning: Disconnect from the mains! Clean the device only with a dry or
damp soft cloth and a mild cleaning agent. Do not allow any water to find its way into
the device. Caution! Never wet clean the device!
14. Do not insert pointed or flat items into the import slot of the device. This can result in
damage to the device and instruments.
15. Do not insert items into the louvres of the device. You may receive an electric shock
or the device could be damaged.
16. Do not use the device if you have any doubts about its safety.
17. The device must not be installed or operated by persons under 16 years of age.
9.696.160
TecnoSeal TA009TAU Chapter 1
Page 5
V 1.01