Technical Parameters - Baxtran ABD Manual De Instrucciones

* ECF-3 CALIBRATION OF WEIGHT (SPAN)
Press the key
Press the keys
Press the key
Press the key
Place the weight of calibration on the platform and press the key
stable.

9. TECHNICAL PARAMETERS

DO NOT MODIFY THE TECHNICAL PARAMETERS IF IT IS NOT STRICTLY NEEDED. A BAD CONFIGURATION OF THIS SECTION
CAN CAUSE A WRONG FUNCTIONING OF THE SCALE.
ENTRANCE AND EXIT OF THE CALIBRATION
DISPLAY
LF 1
CALIBRATION OF THE WEIGHT
DISPLAY
LF 1
CAL Z
150.00 kg
150.00 kg
150.00 kg
38
, the display will show the value of the weight of calibration.
and to move the cursor.
to modify the value of the weight of calibration.
to confirm.
With the visor switched off, press and hold the key
on the screen, then you can release the keys
With the keys , and
Press the key to start or the key
matically.
LF 1
The calibration can be done with any weight, but the weight ca not be inferior to 1/100 of the
maximum capacity and it must also never be exceeded.
•Press the key to start the calibration of zero ( press
to the menu LF1)
•Use , and
bration will be done. ( press the key
•Place the required weight on the scale as it is indicated in the display.
•Once everything is steady, press the key
tion and go back to the menu LF1).
THE CALIBRATION IS GOING TO FINISH AND THE SCALE WILL GO VACK TO THE WEIGHING MODE AUTOMATICALLY.
to do the calibration once the reading is
DESCRIPTION AND SEQUENCE OF USE
and
introduce the code 0020.
to exit the menu and the indicator will begin again auto-
DESCRIPCIÓN y SECUENCIA DE USO
0 ~ 9
, and then pto introduce the weight with which the cali-
to exit the calibration and go back to the menu LF1)
to calibrate it ( press the key ESC to exit the calibra-
USER'S MANUAL ABD
until the message P000, appears
to exit the calibration and go back
EN EN