Setting A Calendar Day Schedule; Setting A Day Interval Schedule; Setting An Odd Or Even Day Schedule - Irritrol LIFE Plus Controller 4 Manual Del Usuario

LIFE Plus Controller 4-8-12-16

Setting a Calendar Day Schedule

The Calendar Day schedule enables you to set each day of the week as an active or
inactive watering day. Each day can be active or inactive in each program A, B, C and
D.
Note: DAY MODE in Settings must be set to WEEKLY.
1. Turn the Programming Dial to the Day Schedule position
2. Press P+ or P- buttons to select the desired program A, B, C or D. Program letter
A, B, C or D will be displayed.
3. Press either the or button to select the day of the week.
4. Press either the or button to set the day On or Off.
5. Repeat steps 3 and 4 for each day of the week.
6. Repeat steps 2-5 for each program as needed.
7. Press the Auto button when finished.
Setting an Odd
or Even Day Schedule
Using an Odd or Even Day watering schedule enables either odd numbered days (1st,
3rd, etc.) or even numbered days (2nd, 4th, etc.) to be selected to water.
Note: DAY MODE in Settings must be set to EVEN/ODD.
1. Turn the Programming Dial to the Day Schedule position
2. Press P+ or P- buttons to select the desired program A, B, C or D. Program letter
A, B, C or D will be displayed.
3. Press either or button to set the Odd Days or Even Days.
4. Repeat steps 2 and 3 for each program as needed.
5. Press the Auto button when finished.
14

Setting a Day Interval Schedule

A Day Interval schedule enables watering days to be set without regard to the actual
days of the week. For example, a 1-day cycle will water every day, a 2-day cycle will
water every other day and so on up to a 31-day cycle, which will water only once a
month.
Note: The active watering day is the last day of the Cycle.
.
In order to establish a reference point for the beginning of the Day Cycle, the number
of days left before watering occurs are also entered.
cycle is selected and "Days left" is entered as
-1, then watering will occur tomorrow.
Note: DAY MODE in Settings must be set to INTERVAL.
1. Turn the Programming Dial to the Day Schedule position
2. Press P+ or P- buttons to select the desired program A, B, C or D. Program letter A,
B, C or D will be displayed.
3. Press either the
4. Press either the
5. Press either the
6. Press either the
is Day ON or the watering day of the cycle).
7. Repeat steps 2–6 for each program as needed.
8. Press the Auto
.
For example, if a 3-day
or button to select the Day Cycle.
or button to set the number of days for Day Cycle.
or button to select the Days Left.
or button to set the number of days left
button when finished.
.
(0 days left