Bulb Replacement - Honda CTX200 Manual Del Propietário

Owner´s Manual

Bulb Replacement

(Refer to the Safety Precautions on page 43.
The light bulb becomes very hot while the light is ON,
and remain hot for a while after it is turned OFF. Be
sure to let it cool down before servicing.
The lighting equipment is not legal for highway use. Do
not operate this motorcycle on public streets, roads or
highways.
• Do not use bulbs other than that specified.
• After installing a new bulb, check that the light
operates properly.
Headlight Bulb
1. Remove the front carrier (1) by removing the bolts (2).
2. Remove the front visor (3) by removing the bolts (4).
3. Disconnect the connector (5).
4. Remove the seat rubber (6).
5. Remove the headlight bulb (7) while pressing down
on the pin (8).
(4)
(2)
(1)
(2)
)
(1) Front carrier
(2) Bolts
(3) Front visor
(4) Bolts
(5) Connector
(5)
(4)
(3)
6. Install a new bulb in the reverse order of removal.
(6)
(7)
Stop/Taillight Bulb
1. Remove the taillight lens (1) by removing the two
screws (2).
2. Slightly press the bulb (3) and turn it
counterclockwise.
3. Install a new bulb in the reverse order of removal.
(3)
(6) Seat rubber
(7) Headlight bulb
(8) Pin
(8)
(1) Taillight lens
(1)
(2) Screws
(3) Bulb
(2)
65