Troubleshooting - Waeco CoolBreeze CB-1200-AC Instrucciones De Montaje

IA_CB-1200.book Seite 49 Montag, 18. April 2005 4:15 16
CB-1200
7

Troubleshooting

Possible
malfunction
System does not
cool
Poor air output
Water enters the
vehicle
Water is
discharged over
the roof
The fresh air
cooling system
cannot be
switched on
All manuals and user guides at all-guides.com
Cause
The device is not in cooling mode. Set the device to cooling mode.
The temperature set is higher that
the room temperature.
The temperature sensor is
defective.
The pollen filter is dirty.
The seals are damaged.
A water hose has a kink or is
clogged.
There is no voltage.
The voltage is too low
(under 200 V)
The voltage converter is defective.
The temperature sensor is
damaged.
The electrical fuse of the power
supply is too low.
Troubleshooting
Remedial measure
Select a lower temperature.
Consult an authorised workshop.
Replace the filter.
Consult an authorised workshop.
Check how the water hoses are laid.
Check the power supply.
Consult an authorised workshop.
Check the electrical fuse of the
power supply.
49