Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IA_CB-1200.book Seite 43 Montag, 18. April 2005 4:15 16
CB-1200
6.5
Installing the fresh air cooling system
You must ensure that the fresh air cooling system is perfectly centred. A
flexible non-hardening sealing compound (e.g. Sika Lastomer-710) must
be applied to the seal before inserting it. The seal must lie flat against the
roof in its entirety after placing it on the roof of the vehicle. This is the only
way to ensure a tight seal!
➤ Lift the fresh air cooling system onto the roof of the vehicle.
Observe the direction of travel (arrow, 7, page 5).
Observe the static of the roof of the vehicle. The roof of the vehicle must
be able to bear the weight of the device. The roof must not be indented or
deformed by the weight of the device, even over a longer period of time.
➤ Position the fresh air cooling system over the installation opening.
Observe the direction of travel!
6.6
Fastening the fresh air cooling system
➤ Install the attachment frame using the fastening materials (threaded
bolts 4 x M8x120 and U washers (4 x M8)) (8 , page 5) that are
included in the scope of delivery.
The supplied threaded bolts (4 x M8 x120) can be used for roofs with a
thickness of up to 65 mm. For other roof thicknesses, you must either use
longer threaded bolts (quality class 8.8) or shorten the ones included.
Attach screw retainers to the fastening bolts!
Tighten to the specified torque!
➤ Screw the threaded bolts 22 mm into the lower shell casing and
tighten the threaded bolts lightly (with 2 counter nuts).
➤ Tighten the retainer nuts (with washers) using a torque spanner and a
fastening torque of 3 Nm (0.3 kgm).
All manuals and user guides at all-guides.com
Installing the fresh air cooling system
43
Publicidad
Tabla de contenido
Solución de problemas
