Bebeconfort ISEOS TT Manual De Instrucciones página 7

• All Bébé Confort products have been carefully designed
and tested for your baby's safety and comfort. Use only
accessories sold or approved by Bébé Confort.
• Using other accessories may prove to be dangerous.
• Please read these instructions carefully and make yourself
familiar with the child seat before using it.
• Always keep the instructions for future reference; there
is a storage pocket specifically provided on the child seat.
UNIVERSAL SYSTEM WITH A 3 POINT SEAT-BELT:
• Approved model
• For Group 1 (babies from 9 to 18kg) ): the seat must be
fitted in a forward-facing position on the rear seats
of the vehicle.
• The child car seat is to be installed facing forwards.
Never install this child car seat facing backwards.
• The manufacturer's liability is limited to what is covered
under the European Regulation (R44). This approval
does not remove the necessity for care and respect
for the Highway Code.
• After putting the child in the car seat, ensure
that the car seat-belt is sufficiently taut by pulling the belt.
Ensure also that the belt does not become twisted
THE CHILD:
• Never leave a child unsupervised.
• Even a gentle impact on a vehicle can turn a child into
a projectile.
• For your own safety and that of your child, always put the
child in the child car seat, however short your journey may be.
• Ensure that the straps under the stomach lie as low as
possible, to properly support the pelvis.
• The temperature inside a vehicle may become very high,
particularly after a long period of exposure to the sun. It
is strongly recommended, under such conditions, to cover
the seat of the car with a piece of material or something
equivalent to prevent the harness fixings, and in particular
the metal parts, from becoming hot and burning the child.
OTHER INSTRUCTIONS:
• This child restraint is effective only if the instructions for
use are respected.
• Always fasten the child restraint even when the child is not
sitting in it.
• The user must always check that any luggage and other
objects likely to cause injury to the occupant of the car seat
in the case of impact are properly secured.
• Never place heavy objects on the rear parcel shelf, to avoid
the danger of projectiles in the event of an accident.
• The rigid parts and the plastic sections of a child restraint
device should be positioned and installed in such a way
that they cannot, when the vehicle is being used under
normal conditions, become trapped under a moving seat
or in the vehicle door.
• Always check that no part of the seat or the harness
is trapped under a seat or in the vehicle door.
• It is essential that the car seat be replaced after an
accident.
• Never modify the construction or the materials of the car
seat and the seat belt without consulting the manufacturer.
• Do not use the child restraint device without the cover.
Do not replace the seat cover with a cover other than that
recommended by the manufacturer, because it will have
a direct effect on the functioning of the child restraint.
IMPORTANT
All manuals and user guides at all-guides.com
• Folding seats must always be locked in place
• After purchasing, install the seat in your vehicle.
If you encounter any installation problems due to the length
of the vehicle seat belt, contact your distributor immediately
(prior to use).
• If in any doubt about the correct installation or use
of the system, the user is advised to contact the distributor
or the manufacturer of the child restraining device system.
To place your child correctly in the ISEOS seat, you
must refer to the instructions on how to place your child
in the car seat on pages 10-11.
The harness should be adjusted to the size of the child
by adjusting the shoulder straps.(pages 24-25)
7
EN