Disposal; Support And Warranty - Imetec P8403 Instrucciones De Uso

Impurities or pieces of
limescale emerge from
the plate.
Water leaks from the
plate.
2 program setting lights
( 8D and 8E) will flash at
the same time and the
iron does not function
The 3 LEDs ( 8D – 8E
– 8A) flash at the same
time and the iron does
not function
The appliance packaging is made of recyclable materials. Dispose of the packaging in
accordance with the environmental protection regulations.
Pursuant to Directive 2012/19/EU on waste electrical and electronic equipment (WEEE), the
crossed bin symbol on the appliance or its packaging indicates that the appliance must be
disposed of separately from other waste at the end of its useful life.
The user must therefore take the appliance to an appropriate recycling centre for electrical and
electronic equipment. Alternatively, instead of handling the disposal, the user can hand over
the appliance to the retailer when a new, equivalent one is purchased. The user can hand over
electronic products measuring less than 25 cm to retailers of electronic products having a sales area
of at least 400 m free of charge and with no obligation to buy. Appropriate separate collection for the
2
subsequent procedure for the decommissioned appliance for recycling, which includes treatment and
environmentally friendly disposal helps prevent adverse effects on the environment and health and
promotes reusing and/or recycling materials that the appliance consists of.
The appliance is guaranteed for a period of two years from the date of delivery. This date is taken as the
date on the receipt/invoice (as long as it is clearly legible), unless the purchaser can prove that delivery
was made at a later date.
In the event of a product flaw already present at the time of delivery, the cost-free repair or replacement
of the appliance is guaranteed unless one of the two solutions is out of proportion with the other. The
purchaser is responsible for informing an authorised assistance centre about the conformity flaw within
two months of discovering it.
Possible limescale residue
inside the iron.
Plate (12) temperature too
low due to pressing the steam
button (13) too frequently.
Type 1 flaw in the electronic
temperature reading system.
Type 2 flaw in the electronic
temperature reading system.

DISPOSAL

SUPPORT AND WARRANTY

Use a damp cloth to remove the impurities
that have deposited on the plate.
Allow slightly longer intervals between the
jets of steam.
Switch off and then back on again. If
the problem persists, contact Customer
Support.
Switch off and then back on again. If
the problem persists, contact Customer
Support.
EN
21