Disposal; Assistance And Warranty - Imetec TITANOX K109 Manual De Instrucciones

Water leaks from
the plate.
The product is packaged in recyclable materials. Dispose of it in compliance with the
environmental protection standards.
Pursuant t o A rt. 2 6 o f I talian L egislative D ecree n o. 4 9 o f 1 4 M arch 2 014 " Implementation
of Directive 2012/19/EU on waste electrical and electronic equipment (WEEE)" the
crossed bin symbol on the appliance or its packaging indicates that the product must
be disposed of separately from other waste at the end of its useful life.
The user must therefore take the appliance to an appropriate recycling centre for electrical
and electronic equipment. Alternatively, instead of handling the disposal, the appliance can
be handed over to the retailer when a new, equivalent appliance is purchased. Retailers of
electronic products having a sales area of at least 400 m2 can also be handed electronic
products that are to be disposed of measuring less than 25 cm, free of charge and with no
obligation to buy. Appropriate separate collection for the subsequent procedure for the
decommissioned appliance for recycling, which includes treatment and environmentally
friendly disposal helps prevent adverse effects on the environment and health and promotes
reusing and/or recycling materials that the appliance consists.
The appliance is guaranteed for a period of 2 years from the date of purchase. Evidence
shall be constituted by the date indicated on the receipt/invoice (provided it is legible),
unless the buyer can prove that the delivery occurred later. In the case of a defective product
existing prior to the date of delivery, IMETEC guarantees to repair or replace the appliance
at no cost, unless one of the two solutions is disproportionate to the other. The buyer has
the obligation to notify an IMETEC Service Centre of the non-conformity within two months
after discovering the defect.
The warranty does not cover any part that may be defective due to:
a. transport damage or accidental drops,
b. incorrect installation or an inadequate electrical system,
c. repairs or alterations made by unauthorised personnel,
d. poor or incorrect maintenance and cleaning,
e. product and/or product parts subject to wear and/or consumables,
f. failure to comply with the operating instructions and/or negligent or careless use.
The list above is purely indicative and not exhaustive and in any case, this warranty shall not
cover all circumstances that cannot be attributed to manufacturing defects of the appliance.
The plate temperature is
too low due to the super-
steam button (4) being
pressed too often.
The temperature
adjustment knob (2) is set
to a temperature that is too
low (Fig. D).

DISPOSAL

ASSISTANCE AND WARRANTy

Allow slightly longer intervals between
the jets of steam.
Turn the temperature adjustment knob
(2) to the Max level (Fig. D).
EN
17