Use; Filling The Tank - Imetec P8403 Instrucciones De Uso

WARNING! This appliance is not to be used if it has been
dropped, if there are visible signs of damage or if it is leaking
water.
WARNING! DO NOT pour diluting agents, scented liquids or
descaling agents into the reservoir as the use of these
substances can damage the product.
WARNING! Do not use water from dryers, air-conditioners or
tumble dryers, filtered water with water softeners, or
rainwater.
The reservoir may contain some water as each product is tested before being put on the market.

FILLING THE TANK

Check that the power supply cable with plug (7) is plugged into the socket.
Open the water fill cover (1).
Pour water into the tank (3) very slowly to avoid overflowing.
Do not exceed the max fill-up level indicated.
Close the water fill cover (1).
SELECTING THE IRONING PROGRAM
Plug the power supply cable with plug (7) into the socket.
Turn the ON/OFF switch (5) to ON.
The INTELLI program indicator light (8D) will flash to indicate that the product is heating up. This program
is suitable for perfectly ironing all types of fabric.
Pressing the program selection button (8C) makes it possible to select the MAX program (8E) to iron
difficult garments, such as jeans, cotton etc.
The plate temperature LED (11) indicates that the iron is warming up.
Wait until the indicator light of the selected program stops flashing before beginning to iron.
It is recommended that you place a cloth between the iron and the fabric when using the iron
for the first time.
Before starting ironing, direct a jet of steam onto the cloth by lifting the iron slightly so that any
residual condensation comes out.
Fabrics with the following symbols may not be ironed:

USE

EN
17