Metabo HPT AC 18DA Instrucciones De Seguridad Y Manual De Instrucciones página 13

5. Exchanging the piston
The piston can be mounted to the rack by simply
screwing it in. No screws or tools are required, so it
is easy to exchange the piston even in the middle of
working. (Fig. 9)
The piston to be used depends on the sealing
material. Refer to Table 6 for the corresponding
pistons.
Piston (for cartridges)
Piston (for sausages)
Piston (for buckets)
Holder Cartridges
300 ml
Included as
standard
(Included with
600 ml
300 ml holder)
For joists
800 ml (Included with
800 ml holder)
6. Exchanging the holder
< Removing the 300 ml holder >
(1) Hold the holder nut and turn the holder in the direction
of the arrow to remove it from the main body. (Fig. 10)
300 ml holder
Rack (push-out rod)
Fig. 9
Table 6
Sausages Buckets
— —
Included Included
with 600 ml with 600 ml
holder holder
— —
Holder nut
Fig. 10
(2) Loosen the screw at the rear of the rack handle and
remove the rack handle from the rack. (Fig. 11)
Rack handle
Screw
(3) While pressing the release button to release the lock,
pull the rack out from the front side of the main body.
(Fig. 12)
Release button
When installing, perform the reverse of the removal
procedure.
< Attaching the 600 ml holder >
(1) Attach the piston that corresponds to the sealing
material to be used by screwing it into the rack.
(2) While pressing the release button to release the
lock, insert the rack from the front side of the main
body. Insert it so that the teeth of the rack are facing
downwards. (Fig. 13)
Release button
English
Rack
Fig. 11
With piston still
attached to rack
Rack
Fig. 12
Make the rack teeth
point downward
Fig. 13
13