Metabo HPT AC 18DA Instrucciones De Seguridad Y Manual De Instrucciones página 14

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
(3) Attach the rack handle to the rack with the screw.
(4) Attach the 600 ml holder by inserting it into the holder
nut and turning it in the direction of the arrow until it
comes into contact. (Fig. 14)
600 ml holder
< Attaching the 800 ml holder >
(1) While pressing the release button to release the lock,
insert the rack from the front side of the main body.
Insert the rack so that the teeth are facing downward
and the female threads are on the rack-handle side.
(Fig. 15)
Female-threaded
Rack handle
side of rack
(2) Attach the rack handle to the rack with the screw.
(3) Attach the 800 ml holder by inserting it into the holder
nut and turning it in the direction of the arrow until it
comes into contact. (Fig. 16)
800 ml holder
14
Holder nut
Fig. 14
Make the rack teeth
point downward
Fig. 15
Holder nut
Fig. 16
(4) Screw the piston onto the rack.
NOTE
When removing the 800 ml holder, remove the piston
from the rack before removing the holder, as the
piston will get stuck when the holder is removed.
7. Loading the sealing material
CAUTION
Please also check the information on the sealing
material package before use.
< Cartridges >
(1) Cut off the tip of the nozzle at an angle. (Fig. 17)
3 mm or larger
(2) Remove the nozzle and use the cut end to break the
membrane inside the cartridge, then return it to its
original position. (Fig. 18)
Nozzle
Fig. 17
Nozzle
Fig. 18

Publicidad

Tabla de contenido
loading

Tabla de contenido