Prior To Operation - Metabo HPT AC 18DA Instrucciones De Seguridad Y Manual De Instrucciones

English
CAUTION
● When the battery charger has been continuously
used, the battery charger will be heated, thus
constituting the cause of the failures. Once the
charging has been completed, give 15 minutes
rest until the next charging.
● If the battery is charged while it is heated
because it has been left for a long time in a
location subject to direct sunlight or because
the battery has just been used, the pilot lamp of
the charger lights for 1 second, does not light for
0.5 seconds (off for 0.5 seconds).
The battery will not be recharged. In such a
case, let the battery cool before charging.
● When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any foreign
objects in the charger's battery connector. If
there are no foreign objects, it is probable that
the battery or charger is malfunctioning. Take it
to your authorized Service Center.

PRIOR TO OPERATION

CAUTION
To avoid serious accident, ensure the switch is
in the OFF position, and pull out the battery.
1. Check the work area environment
Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
2. Power switch
Ensure that the switch is in the OFF position.
3. Using the hook
You can use the hook to briefl y set aside the tool
during operation.
You can change the hook's position to the left or right.
12
Hook
Fig. 7
WARNING
● The hook is not for hanging the tool on your
person.
To avoid injury, do not hang the tool from your
belt, trousers or any other part of your body.
● Do not use the hook in high places.
Doing so could result in unexpected accidents
such as dropping the tool.
● When using the hook, make sure the tool is
placed in a stable location where it won't slip off
or be dislodged by wind.
CAUTION
Install securely the hook. Unless the hook is
securely installed, it may cause an injury while
using.
(1) Installing the hook.
Install securely the hook in the groove of power tool
and tighten the screws to fi x the hook fi rmly. (Fig. 8)
Groove
4. Types of sealing materials
There are three types of sealing materials that the
tool can use.
Refer to Table 5 for the appropriate holder for the
sealing material you are using.
Sealing material
Cartridges
for joists
Sausages
Buckets
CAUTION
Before use, refer also to the directions on the
packaging of the sealing material to ensure that
you use it correctly.
NOTE
Do not make the diameter of the cut cross-section
of the nozzle 3 mm or smaller. Doing so may cause
leakage of sealing material on the piston side or
damage to the cartridge.
Screw
Hook
Fig. 8
Table 5
Holder
300 ml holder
800 ml holder (sold separately)
600 ml holder (sold separately)