Metabo HPT C 1810DFA Instrucciones De Seguridad Y Manual De Instrucciones página 20

English
8 mm Bolt (B)
(Stopper for left 45°
bevel angle)
Fig. 16-b
3. Securing the workpiece
WARNING
Always clamp or vise to secure the workpiece
to the fence; otherwise the workpiece might be
thrust from the table and cause bodily harm.
4. Installing the holder ... (Optional accessory)
The holder helps keep longer workpieces stable and
in place during the cutting operation.
○ As indicating in Fig. 17, installing the holder in the
holes on the side of base and fasten it with 6 mm
machine screw (Optional accessory).
6 mm Machine screw
(Optional accessory)
Holder
(Optional accessory)
5. Installing the holders ... (Optional accessory)
The holders help keep longer workpieces stable and
in place during the cutting operation.
(1) As indicated in Fig. 18, use a steel square for aligning
the upper edge of the holders with the base surface.
Loosen the 6 mm wing nut. Turn a height adjustment
bolt 6 mm, and adjust the height of the holder.
20
Base
Fig. 17
(2) After adjustment, fi rmly tighten the wing nut and
fasten the holder with the 6 mm wing bolt (optional
accessory). If the length of Height Adjustment Bolt
6 mm is insuffi cient, spread a thin plate beneath.
Make sure the end of Height Adjustment Bolt 6 mm
does not protrude from the holder.
Holder
(Optional
Steel square accessory)
6 mm Wing nut
(Optional accessory)
6. Stopper for precision cutting ... (Stopper and holder
are optional accessory)
The stopper facilitates continuous precision cutting in
lengths of 11 in. to 17-3/4 in. (280 mm to 450 mm).
To install the stopper, attach it to the holder with the
6 mm wing bolt as shown in Fig. 19.
Workpiece
Move
6 mm Wing bolt
(Optional accessory)
6 mm Wing bolt
(Optional accessory)
Base surface
Height adjustment bolt 6 mm
(Optional accessory)
Fig. 18
Stopper
(Optional accessory)
Holder
(Optional accessory)
6 mm Wing nut
(Optional
accessory)
Height adjustment
bolt 6 mm
(Optional accessory)
Fig. 19