Practical Applications - Metabo HPT C 1810DFA Instrucciones De Seguridad Y Manual De Instrucciones

7. LED lighting system (Fig. 20) [XACT CUT LED™]
CAUTION
Do not stare at operating lamp. Staring into the
light beam may result in serious injury or vision
loss.
LED light switch
Shadow of blade teeth
projected onto workpiece
The LED lighting system [XACT CUT LED™] casts the
shadow of the blade onto the workpiece. This results in
greater accuracy of cuts and requires no adjustments.
To use this feature, turn the LED light switch on.
Bring the motor head down so the blade is approximately
1/4 in. (6 mm) from the workpiece. The shadow of the blade
will be projected onto the workpiece, indicating where the
blade teeth will make contact as the cut is made.

PRACTICAL APPLICATIONS

WARNING
● To avoid personal injury, never remove or place
a workpiece on the table while the tool is being
operated.
● Never place your limbs inside of the line next to
warning sign while the tool is being operated.
This may cause hazardous conditions (see
Fig. 21).
CAUTION
○ It is dangerous to remove or install the workpiece
while the saw blade is turning.
○ When sawing, clean off the shavings from the
turntable.
Fig. 20
○ If the shavings accumulate too much, the saw blade
from the cutting material will be exposed. Never
subject your hand or anything else to go near the
exposed blade.
NOTE
Prior to operating the switch, make sure to check the
stability of the tool by setting the angle and turn to
conduct a trial cutting run without using a workpiece.
Line Warning sign
Warning sign Line
1. Switch operation
The tool will not start unless the lock-off button is pressed
while the switch is pulled back.
The Lock-off button can be engaged by pressing it to right.
After the switch is on, the saw blade will continue to
operate as long as you pull on the trigger switch, even if
you release the lock-off button.
When the switch is released, the lock-off button
automatically disengages to prevent inadvertent motor
startup.
English
Fig. 21
Trigger switch
Lock-off button
Fig. 22
21