Metabo HPT C 1810DFA Instrucciones De Seguridad Y Manual De Instrucciones página 25

Miter angle
scale
Turntable
(2) Setting to cut crown moldings at positions
in Fig. 28 (see Fig. 30; tilt the head to the left):
Turn the turntable to the left and set the Miter Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
Tilt the head to the left and set the Bevel Angle as
follows:
○ For 45° type crown moldings:
○ For 38° type crown moldings:
Position the crown molding so that the lower surface
(Ⓑ in Fig. 27) contacts the fence as in Fig. 32.
Fence
(Left side)
Head
Bevel angle scale
Fence
(Right side)
Base
Fig. 29
35.3°
31.6°
30°
33.9°
Head
Bevel angle scale
Base
Turntable
Miter angle scale
Fig. 30
Fence
Ⓐ
Fence
Ⓑ
and
Cutting method of crown molding without tilting the saw
blade.
(1) Crown molding Stopper (L) and (R) (optional
accessories) allow easier cuts of crown molding
without tilting the saw blade. Install them in the
base both-sides side to be shown in Fig. 33-a. After
inserting Tighten the 6 mm knob bolts to secure the
crown molding Stoppers.
[Optional accessories used]
• Crown molding Vise Ass'y (Include Crown molding
Stopper (L))
• Crown molding Stopper (L)
• Crown molding Stopper (R)
Crown molding
vise ass'y
(Optional accessories)
6 mm Wing
bolt
6 mm Wing bolt
English
Ⓑ
Table on base
Fig. 31
Ⓐ
Table on base
Fig. 32
Crown molding stopper (R)
(Optional accessories)
6 mm Wing
bolt
Crown molding stopper (L)
(Optional accessories)
Fig. 33-a
25