Metabo HPT C 1810DFA Instrucciones De Seguridad Y Manual De Instrucciones página 26

English
(2) The crown molding vise (B) (Optional accessory) can
be mounted on either left side of the fence or the right
side of the fence. It can unite with the slope of the
crown molding and vice can be pressed down.
Then turn the upper knob, as necessary, to securely
attach the crown molding in position. To raise or lower
the vise assembly, fi rst loosen the 6 mm knob bolt.
After adjusting the height, fi rmly tighten the 6 mm
wing bolt; then turn the upper knob, as necessary, to
securely attach the crown molding in position. (See
Fig. 33-b)
Crown molding vise ass'y
(Optional accessories)
6 mm
Knob bolt
Fence
6 mm Wing bolt Crown molding
Fig. 33-b
WARNING
Always fi rmly clamp or vise to secure the crown
molding to the fence; otherwise the crown
molding might be thrust from the table and cause
bodily harm.
Do not bevel cutting. The main body or saw blade
may contact the sub fence, resulting in an injury.
CAUTION
Always confi rm that the motor head (see Fig. 2)
does not contact the crown molding vise ass'y
when it is lowered for cutting. If there is any
danger that it may do so, loosen the 6 mm knob
bolt and move the crown molding vise ass'y to a
position where it will not contact the saw blade.
Position crown molding with its WALL CONTACT
EDGE against the guide fence and its CEILING
CONTACT EDGE against the crown molding Stoppers
as shown in Fig. 33-b.
Adjust the crown molding Stoppers according to the
size of the crown molding.
Tighten the 6 mm wing bolt to secure the crown
molding Stoppers.
26
Knob
Crown molding stopper (L)
Crown molding stopper (R)
(Optional accessories)
8. Cutting easily-deformed materials, such as aluminum
sash
Materials such as aluminum sash can easily deform
when tightened too much in a vise assembly. This will
cause ineffi cient cutting and possible overload of the
motor.
When cutting such materials, use a wood plate to
protect the workpiece as shown in Fig. 34-a. Set the
wood plate near the cutting section.
When cutting aluminum materials, coat the saw blade
with cutting oil (non-combustible) to achieve smooth
cutting and a fi ne fi nish.
In addition, in case of a U-shaped workpiece, use the
wood plate as shown in Fig. 34-b to ensure stability
in the lateral direction, and clamp it near the cutting
section of the workpiece and tighten it using both the
vise assembly and the clamp available in the market.
Fence
6 mm Knob bolt
Fig. 34-a
Vise assembly
Fence
Wood plate
Fig. 34-b
9. How to use the dust bag (Standard accessory)
(1) When the dust bag has become full of sawdust, dust
will be blown out of the dust bag when the saw blade
rotates.
Check the dust bag periodically and empty it before it
becomes full.
(2) During bevel and compound cutting, attach the dust
bag at a right angle to the base surface as shown in
Fig. 35.
Vise assembly
Wood plate
Aluminum sash
Wood plate
Clamp
Wood plate
Aluminum sash