Moving Zone, Group, Autozone Or Message Selection Buttons In An Area; Change The Text Color Of The Zone, Group, Autozone Or Prerecorded Message Buttons - Optimus DC-700ETH/T Manual De Instalación

DC-700ETH/T

To modify AutoZone buttons:
1. With the Edit Mode activated, long press and hold the button you want to modify.
2. Select the Edit icon.
3. Modify the desired parameters and press OK.
If you do not wish to carry out any more configuration operations on the DC-700ETH/T display, exit the Edit Mode (see
section 3.3.2.1).

3.3.2.7 Moving zone, group, AutoZone or message selection buttons in an area

It is possible to move and position the zone, group, AutoZone and pre-recorded message selection buttons to any desired
position within an area. Thus, if a background image is used (e.g. the floor plan of a building), the various selection buttons
can be arranged in the corresponding position on the floor plan.
To this end:
1. Activate the Edit Mode (see section 3.3.2.1).
2. Select the area where the buttons to be moved are located.
3. Select the button and holding it down drag it to the location in the area where you want to place it. Release to anchor
the element.
If you do not wish to carry out any more configuration operations on the DC-700ETH/T display, exit the Edit Mode (see
section 3.3.2.1).

3.3.2.8 Change the text color of the zone, group, AutoZone or prerecorded message buttons.

1. Activate the Edit Mode (see section 3.3.2.1).
2. Select the area where the buttons whose text color you want to change are located.
3. Long press and hold the button. A circular selection menu appears.
4. Select the Text color icon.
5. Select the desired color and press OK. You can also hide the text by
unchecking the VISIBLE checkbox.
If you do not wish to carry out any more configuration operations on the DC-
700ETH/T display, exit the Edit Mode (see section 3.3.2.1).
Configuration and User Manual. Version 5.2.001
DC-700ETH/T.
Configuration and user's manual
R+D Department
3. START-UP
25