Add/Remove Zone Selection Buttons To An Area - Optimus DC-700ETH/T Manual De Instalación

DC-700ETH/T

3.3.2.3 Add/Remove zone selection buttons to an area


To add zone selection buttons:
1. Activate the Edit Mode (see section 3.3.2.1).
2. Select the area where you want to add the zone selection
buttons.
3. Long press and hold on any point in an area free of
elements and a circular selection menu will appear.
4. Select the Add icon.
5. Select the Zone icon.
6. The list of available zones appears. In the
select the zones you want to add.
7. Press OK.

To delete zone selection buttons:
1. With Edit Mode activated, long press and hold the button you want to delete.
2. Select the Delete icon.
3. Select YES to confirm deletion.
If you do not wish to perform any further configuration operations on the DC-700ETH/T display, exit the Edit Mode (see
section 3.3.2.1).
Configuration and User Manual. Version 5.2.001
DC-700ETH/T.
Selected column,
R+D Department
Configuration and user's manual
3. START-UP
Zone selection
button
21