Add/Remove Autozone Buttons To An Area - Optimus DC-700ETH/T Manual De Instalación

DC-700ETH/T

3.3.2.6 Add/Remove AutoZone buttons to an area

The AutoZone button allows, by means of a single button, to send a pre-recorded message to
the zones and groups that have been previously configured. Adding the button assigns the
message and the target zones/groups.

To add AutoZone buttons to an area:
1. Activate the Edit Mode (see section 3.3.2.1).
2. Select the area where you want to add the AutoZone buttons.
3. Long press and hold on any point in an area free of elements and a circular selection menu will appear.
4. Select the Add icon.
5. Select the AutoZone
6. The list of available ZONES,
GROUPS and pre-recorded
MESSAGES is displayed in three
columns. Select a message and
the desired zones and groups.
If you wish, you can enter an
identifying name in the
CONFIG. field and activate the
GONG tone (tone that will
precede the message).
7. Press OK.
Repeat this process
AutoZone button you wish to have in
the area.

To delete AutoZone buttons:
1. With Edit Mode activated, long press and hold the button you want to delete.
2. Select the Delete icon.
3. Select YES to confirm deletion.
Configuration and User Manual. Version 5.2.001
DC-700ETH/T.
icon.
AUTO
for each
Configuration and user's manual
R+D Department
3. START-UP
AutoZone button
24