Door Handle Installation - IKEA STJARNSTATUS Manual Del Usuario

EN
CAUTION
Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.
Door Handle
Mounting Instructions
1. Remove handles from carton and
any other protective packaging.
2. Position refrigerator handle end
caps over upper and lower pre-
installed shoulder bolts (A) that are
fastened into door, ensuring the
holes for the set screws are facing
towards the opposite door.
3. While holding handle firmly
against door, fasten upper and
lower Allen set screws (B) with
supplied Allen wrench.
4. Repeat steps 2 and 3 to install
opposite handle. Ensure the holes
for the set screws are facing
towards the opposite door.
5. Position freezer handle end caps
over left and right pre-installed
shoulder bolts (A) that are fastened
to the door, ensuring the holes for
the set screws are facing down.
6. While holding handle firmly against
door, loosely tighten right Allen set
screw (B) with supplied Allen wrench
until there is no gap between
handle and door.
7. Still holding the handle firmly to the
door, firmly tighten left Allen set
screw (B) with supplied Allen wrench.
8. Return to the right Allen set screw
(B) and firmly tighten with supplied
Allen wrench.

NOTE
All set screws should be tightened so the screw is below the surface of the handle. The
handles should be drawn tight to freezer and refrigerator doors with no gaps. Opening
the opposite door while tightening the Allen screw makes installation easier.
The door handle may loosen over time or if it was installed improperly. If this happens,
tighten the set screws on the handles.

DOOR HANDLE INSTALLATION

B
B

NOTE
When tightening the Allen set screws, it
is important that force be applied to the
longer arm of the Allen wrench supplied
in the handle packaging.
A
A
B
A
B
A
17