Dometic SMRTSTACR Manual De Instalación Y Funcionamiento página 12

Installation
7 .1 .1 Removing the Shrouds
15 Brisk II AC Unit Components and Screw Locations
AC Shroud
q
AC Shroud Screws
w
1. Using the #2 Phillips screwdriver, remove and set
aside the four AC shroud screws and the AC shroud.
The AC shroud should lift off easily. If it does
I
not, verify all the AC shroud screws have been
removed.
I Turn the AC shroud upside down to store the
screws and other small parts removed during
the installation process.
2. Remove the internal foam shroud by pulling up
vertically on the sides and set it aside.
12
q q
w w
e e
r r
Foam Shroud
e
Electrical Box
r
16 Removing the Electrical Box Cover
Electrical Box Cover
q
Screws
Electrical Box
w
3. Using the 5/16 in. deep well nut driver, remove the
two screws on the top of the electrical box cover and
set aside.
4. Remove the electrical box cover from the electrical
box, sliding the electrical box cover up and away
from the electrical box.
SmartStart RV Soft Start Accessory
q q
w w
e e
Electrical Box
e
Cover
EN