Dometic SMRTSTACR Manual De Instalación Y Funcionamiento página 21

SmartStart RV Soft Start Accessory
7 .3 .1 Removing the Covers
34 Removing the Covers and Foam
AC Shroud
q
AC Shroud
w
Screws
Foam Shroud
e
1. Using the #2 Phillips screwdriver, remove the nine AC
shroud screws and the AC shroud.
The AC shroud should lift off easily. If it does
I
not, verify all the AC shroud screws have been
removed.
I Turn the AC shroud upside down to store the
screws and other small parts removed during
the installation process.
EN
q q
w w
e e
t t
y y
r r
Electrical Box Foam
r
Electrical Box
t
Cover
Electrical Box Cover
y
Screws
2. Remove the internal foam shroud by pulling up
vertically on the sides and set aside.
3. Expose the electrical box cover screws by pulling
forward on the electrical box foam.
4. Using the 5/16 in. deep well nut driver, locate and
remove the two screws from the sides of the electrical
box.
7 .3 .2 Disconnecting the Compressor
Wires
q q w w
e e
r r
35 Disconnecting the Compressor Wires from the Capacitor
Compressor Wire Harness
q
Red Compressor
w
Wire
White Compressor
e
Wire
1. Using the needle nose pliers, remove the blue wire
from the relay block inside the electrical box.
2. Remove the compressor wires from the capacitor.
The wires can be traced from outside the electrical
box as part of the red, white, and blue wire harness.
3. Remove the white compressor wire from the piggy-
back connector.
4. Reconnect the piggy-back connector to its original
terminal location.
Installation
y y
t t
Capacitor
r
Wire Tie
t
Blue Compressor
y
Wire
21