Dometic SMRTSTACR Manual De Instalación Y Funcionamiento página 14

Installation
7 .1 .3 Installing the New Supply Wire
Harness
20 Connecting the Harnesses
Supply Wire Harness
q
1. Insert the AC wire harness plug into the supply wire
harness included with the device.
w w
21 Securing the Strain Relief
Gasket Putty
q
Foam Electrical
w
Enclosure
2. Remove the gasket putty, reserving it for later reuse.
3. Using the 5/16 in. deep well nut driver, locate and
remove the outer strain relief screw from the strain
relief.
4. Route the blue wire from the supply wire harness
through the foam electrical enclosure and strain relief.
14
q q
w w
AC Wire Harness Plug
w
q q
r r
e e
Strain Relief Screw
e
Existing Cable Route
r
I Use the existing cable as a guide for routing the
blue wire.
5. Using the 5/16 in. deep well nut driver, insert the
outer strain relief screw into the strain relief and
tighten until snug.
q q
w w
r r
22 Routing Wires through the Fan Motor Mount to the Capacitor
Control Box Cavity
q
Red and White
w
Capacitor Wires
Fan Motor Mount
e
(first hole)
6. Route the supply wire harness through the control
box cavity.
7. Insert the red and white supply harness wires into the
first hole of the fan motor mount and push the wires in
toward the second fan motor mount hole.
8. From the condenser side of the fan motor mount,
reach into the fan motor mount and pull the red and
white capacitor wires through the second hole in the
fan motor mount.
I Before passing the wires through the second
fan motor mount hole, arrange them to curve
toward the condenser to easily pass from the fan
motor mount to the hole in the electrical box.
9. Pull the red and white wires through the second fan
motor mount hole and into the electrical box, pulling
them through to the electrical box area.
SmartStart RV Soft Start Accessory
e e
t t
y y
Capacitor
r
Fan Motor Mount
t
(second hole)
Wire Bundle
y
EN