Dometic SMRTSTACR Manual De Instalación Y Funcionamiento página 13

SmartStart RV Soft Start Accessory
7 .1 .2 Disconnecting the Compressor
Wires
17 Disconnecting the Compressor Wires from the Capacitor
Capacitor
q w
1. Disconnect the red and white compressor wires from
the capacitor inside the electrical box.
q q
w w
r r
r r
r r
e e
18 Disconnecting the Compressor Wires from the Compressor
Compressor
q
Cap Nut
Compressor Cap
w
Compressor
e
EN
w w
q q
Red and White Compressor
Wires
y y
t t
White, Red, and Blue
r
Factory Compressor Wires
Wire Tie
t
Fan Motor Mount
y
2. Using the 5/16 in. deep well nut driver, locate and
remove the compressor cap nut and compressor cap
from the top of the compressor.
3. Disconnect the white, red, and blue factory
compressor wires from the compressor.
4. Using a 6 in. (15.2 cm) length of electrical tape,
secure the compressor wire terminals together
and cover the terminal ends with tape. Use more
electrical tape if needed to cover the terminal ends
completely to ensure no metal is exposed.
q q
e e
19 Disconnecting the Compressor Wire Harness
Compressor Wire
q
Harness
Strain Relief
w
5. Tuck the taped factory compressor wires into the
foam electrical enclosure.
6. Starting at the compressor, trace the white wire to the
fan motor mount.
7. Using your fingers to pinch the white wire close to
the fan motor mount, pull on the white wire to verify it
is loose and not attached to the capacitor.
Installation
w w
Factory Compressor
e
Wires inside the Foam
Electrical Enclosure
13