Dometic SMRTSTACR Manual De Instalación Y Funcionamiento página 15

SmartStart RV Soft Start Accessory
10. On the capacitor:
a. Connect the red wire to the HERM terminal.
b. Connect the white wire to the COM terminal.
11. Use a wire tie to secure the new supply harness
wires, and the factory compressor wires terminals
disconnected from the capacitor, to the existing
wire bundle.
12. Ensure the secured factory compressor wires cannot
come into contact with the top of the capacitor.
7 .1 .4 Mounting the Device - Brisk II AC
Unit
NOTICE: If the fan motor washers stick to the fan motor
grommets, use the needle nose pliers to carefully pry
them off. Do not use a screwdriver or sharp object.
Failure to follow this notice can damage the fan motor
grommets.
This section describes how to mount the device onto a
Brisk II AC unit.
w w
e e
r r
t t
23 Mounting the Device and Mounting Bracket for the Brisk II
Device
q
Supply Side
w
Z-Brackets
e
1. Locate the fan motor in the AC unit.
2. Using the 5/16 in. deep well nut driver, remove the
four fan motor nuts from the fan motor studs and set
aside.
3. Remove and discard the four fan motor washers
without damaging the fan motor grommets
underneath.
EN
q q
y y
Fan Motor Nuts
r
Fan Motor Studs
t
Fan Motor
y
4. Holding the device with the supply side of the device
towards the compressor, place the device onto the
fan motor so the mounting studs pass through the
holes in the z-brackets.
5. Replace and tighten the four fan motor nuts until snug.
7 .1 .5 Replacing the Electrical Box Cover
q q
w w
24 Replacing the Electrical Box Cover
Electrical Box Cover
q
Screws
Electrical Box Cover
w
Interior Tabs
1. Place the electrical box cover on the electrical box,
aligning the electrical box cover interior tabs with the
electrical box base cutout features.
2. Once aligned, push the electrical box cover in and
then down to seat it in place.
I When the electrical box cover is installed
correctly, the upper edge of the electrical
box should not move or pivot if pulling on the
bottom of the electrical box.
3. Insert the two electrical box cover screws on the top
of the electrical box cover.
4. Using the 5/16 in. deep well nut driver, tighten the
electrical box cover screws until snug.
Installation
e e
r r
Electrical Box Base
e
Cutout
Electrical Box
r
15