Dometic SMRTSTACR Manual De Instalación Y Funcionamiento página 24

Installation
7 .3 .5 Connecting the New Compressor
Wire Harness
NOTICE: When routing the compressor wire harness,
the compressor wire harness should route under the
foam. Failure to follow this notice could cause the fan
motor shaft to damage the compressor wire harness.
t t
q q
e e
w w
41 Connecting the Compressor Wire Harness
White Compressor
q
Wire Terminal 'R(U)'
Compressor
w
Compressor Wire
e
Harness
1. Using the compressor wire harness from the
installation kit, connect the white, red, and blue wires
to the compressor.
q q
w w
42 Routing the Compressor Wire Harness
Compressor Cap
q
Nut and Washer
Compressor Cap
w
24
r r
Blue Compressor
r
Wire
Red Compressor
t
Wire Terminal 'S(V)'
r r
e e
r r
Compressor Wire
e
Harness Path
Wire Ties
r
2. Route the compressor wire harness, ensuring it
passes over the existing wire ties.
3. Finish routing the compressor wire harness under
the foam, between the foam and the fan motor, by
pulling the compressor wire harness through to the
opposite side of the fan motor.
4. Using wire ties, gather and secure all the wires and
cables between the fan motor and the compressor.
5. Using the 5/16 in. deep well nut driver, replace the
compressor cap and compressor cap nut onto the
top of the compressor and tighten.
7 .3 .6 Mounting the Device
u u
w w
q q
e e
r r
43 Placing the Device on the Fan Motor
Fan Motor
q
Fan Motor Nuts
w
Fan Motor Washers
e
Fan Motor Grommets
r
1. Viewing the fan motor from directly above, identify
the gap between the fan motor and the mounting
flange on the condenser side of the coil.
2. Holding the device with the supply side of the device
towards the compressor, center the starter over the
fan motor.
3. Lower the hose clamp into the gap between the fan
motor and the mounting flange.
SmartStart RV Soft Start Accessory
t t
y y
Fan Motor
t
Studs
Base Pan Frame
y
Device
u
EN