Dometic SMRTSTACR Manual De Instalación Y Funcionamiento página 16

Installation
7 .1 .6 Connecting the Supply and
Compressor Wire Harnesses
1. Connect the supply wire harness to the supply side
of the device. If necessary, pull more of the blue wire
through the strain relief.
q q
w w
e e
r r
t t
y y
25 Connecting the Compressor Wire Harness to the Compressor
Compressor
q
Nut
Compressor
w
Cap
White Compressor
e
Wire Terminal 'R(U)'
2. Using the compressor wire harness, connect the
white, red, and blue compressor wires to the
compressor.
3. Replace the compressor cap and compressor cap nut
onto the top of the compressor.
4. Use the 5/16 in. deep well nut driver to tighten the
compressor cap nut.
5. Route the compressor wire harness along the same
path as the supply wire harness toward the device.
16
Red Compressor
r
Wire Terminal 'S(V)'
Blue Compressor
t
Wire
Compressor Wire
y
Harness Path
e e
w w
26 Connecting the Compressor Wire Harness to the Device
Device
q
Compressor Wire
w
Harness
6. Replace the foam shroud.
7. Connect the compressor wire harness to the
compressor side of the device.
8. Secure the compressor wire harness in place using
the wire ties.
a. Tie the compressor wire harness and blue wire to
the existing wire bundle.
b. Tie the compressor wire harness to the supply
side harness of the control.
9. Spread the reserved gasket putty around the entire wire
harness to seal the area where it enters the foam shroud.
The gasket putty seal keeps outside air, dirt,
I
bugs, and other contaminants from entering
directly into the RV air ducts. Thoroughly spread
and press the putty into the opening to ensure a
quality seal.
7 .1 .7 Replacing the AC Shroud
1. Place the AC shroud onto the base of the AC unit.
2. Using the #2 Phillips screwdriver, replace the four AC
shroud screws and secure the AC shroud in place.
SmartStart RV Soft Start Accessory
q q
r r
e e
Wire Ties
e
Foam Shroud
r
Gasket Putty
t
t t
EN