Installing The Device In A Blizzard Nxt Ac Unit - Dometic SMRTSTACR Manual De Instalación Y Funcionamiento

Installation
7 .2 .5 Connecting the Compressor Wire
Harness
q q
w w
e e
33 Connecting the Compressor Wire Harness
Compressor Cap Nut
q
and Washer
Compressor Cap
w
Compressor
e
Compressor Wire
r
Harness
1. Route the compressor wire harness through the
housing wall.
2. Connect the white, red, and blue compressor wires
to the compressor.
I The red wire must fold back on itself to route
properly.
3. Using the 5/16 in. deep well nut driver, replace and
secure the compressor cap with the compressor cap
washer and nut.
4. Secure the factory compressor wires to the new
compressor wire harness using wire tie(s).
20
u u
t t
y y
r r
Blue Compressor
t
Wire
White Compressor
y
Wire
Red Compressor
u
Wire
7 .2 .6 Replacing the Covers
1. Replace the reserved gasket putty to seal the holes
where the wire harness passes in and out of the
housing wall:
a. Split and roll the putty into two equal-size balls.
r r
b. Press one gasket putty ball into the hole where the
wire harness passes through the housing wall.
c. Press the other gasket putty ball into the hole on
the other side of the housing wall where the wire
harness passes through.
I The gasket putty seal keeps outside air, dirt,
bugs, and other contaminants from entering
directly into the RV air ducts. Thoroughly spread
and press the putty into the opening to ensure a
quality seal.
2. Replace the electrical box cover on the electrical box.
3. Using the 5/16 in. deep well nut driver, insert and
tighten until snug the two electrical box cover screws.
4. Replace the wire tie in the same approximate location
where it was removed and trim the wire tie end after
tightening.
5. Replace the foam gasket into its original position
without compressing on itself.
6. Replace the AC shroud onto the base of the AC unit.
7. Using the #2 Phillips screwdriver, replace the four AC
shroud screws and tighten to secure the AC shroud
in place.
7 .3 Installing the Device in a
Blizzard NXT AC Unit
NOTICE: Do not force the AC shroud during removal.
Failure to follow this notice can damage or break the
screw holes and require an AC shroud replacement.
This section describes how to access the installation
area, disconnect the existing wiring, mount the device,
install and connect the new wiring, and close the unit
after completing the installation in a Blizzard NXT AC
unit.
SmartStart RV Soft Start Accessory
EN