Mounting The Device - Dometic SMRTSTACR Manual De Instalación Y Funcionamiento

SmartStart RV Soft Start Accessory

7 .2 .3 Mounting the Device

w w
q q
31 Mounting the Device and Mounting Bracket Assembled
Fan Motor
q
Device
w
1. Holding the device with the compressor side towards
the compressor, center the device on top of the fan
motor.
2. Avoiding any wires, route the mounting bracket hose
clamp ends around the fan motor so the ends meet.
3. Use the connected worm screw to hold the mounting
bracket hose clamp ends loosely around the fan
motor.
I If the mounting bracket moved during the
previous step, shift the mounting bracket back
to realign at the center of the fan motor.
4. Using the worm screw, finish tightening the aligned
mounting bracket around the fan motor to 40 in. lbs
(4.5 N·m).
EN
e e
Device - Compressor
e
Side
7 .2 .4 Connecting the Supply Wire
Harness
w w
e e
32 Connecting the Supply Wire Harness
Supply Wire
q
Harness
Blue Supply Wire
w
Condenser Coil
e
1. Route the supply wire harness from the device into
the electrical box.
2. Connect the red supply wire to the HERM terminal.
3. Connect the white supply wire to the COM terminal.
4. Connect the blue supply wire to the relay block.
5. Place the wires inside the strain relief and reinsert the
strain relief into the housing wall hole.
6. Ensure the strain relief is secure in the hole.
7. Secure the factory compressor wires and the device
wire harness together using wire tie(s). Ensure that the
factory wires cannot move or damage the condenser
coil.
Installation
q q
y y
r r
t t
Red Supply Wire to
r
HERM Terminal
White Supply Wire to
t
COM Terminal
Strain Relief
y
19