Dometic SMRTSTACR Manual De Instalación Y Funcionamiento página 28

Bracket Assembly
w w
50 Attaching the Hose Clamp (Supply Side on the Right)
Device Cover
q
Slot - Compressor
w
Side
Mounting Bracket
e
Hose Clamp
r
Worm Screw
t
9. Insert the hose clamp end into the slot on the supply
side of the mounting bracket.
10. Push the hose clamp through to the other side of the
mounting bracket.
I If it is difficult to push the hose clamp through
the mounting bracket, loosen the nuts on the
bracket screws several turns.
11. Push the hose clamp end through the slot on the
compressor side of the mounting bracket.
If the hose clamp does not easily align with the
I
compressor side slot, use the needle nose pliers
to guide it into place.
12. Continue pushing the hose clamp through the
mounting bracket until the worm screw is next to the
top slot on the supply side of the device.
13. Using the torque wrench and the #2 Phillips
screwdriver, tighten the nuts on the bracket screws
to 30 in. lbs (3.4 N·m).
28
q q
o o
i i
e e
y y
t t
r r
Slot - Supply Side
y
Bracket Screws
u
Nuts
i
Device - Supply Side
o
14. Aligning the fiber optic rods on the underside of
device cover to the LEDs in the device, replace the
device cover.
15. Tighten the device cover screws.
u u
SmartStart RV Soft Start Accessory
EN