Change The Air Filter (03); Changing The Oil (07); Clean Engine And Silencer (08); Clean The Air Filter (09) - AL-KO PRO 350 Manual De Instrucciones

GB
7.1

Change the air filter (03)

NOTE
■
The filter element must be kept free of grass
residue and dirt.
■
Only replace filter elements with original
spare parts.
■
The engine must never be operated without a
properly installed filter element.
Clean the air filter regularly. Renew air filters if
damaged.
1. Clean the area around the filter cover (03/1).
2. Unscrew the two knobs (03/2) of the filter
cover and remove the filter cover.
3. Pull out filter element (03/3).
4. Check the condition of the filter element. The
filter element must be in perfect condition,
clean and fully functional. Otherwise the filter
element must be serviced or replaced.
5. Insert the filter element and refit the filter cov-
er.
7.2

Changing the oil (07)

Check the oil level regularly. Check the oil level
every 5 operating hours or every day before start-
ing the engine (see chapter 4.2.1 "Filling with en-
gine oil (02)", page 20).
WARNING! Danger of explosion and fire.
Escaping fuel will create an explosive petrol/air
mixture. Deflagration, explosion and fire can lead
to serious and even fatal injuries if fuel is not han-
dled properly.
■
Empty the fuel tank before draining the oil.
NOTE
■
Drain off the old oil when the engine is warm.
Warm oil runs out quickly and fully.
■
Dispose of used oil in an eco-friendly man-
ner!
1. To empty the fuel tank: Allow the engine to
run until it stops itself.
Or drain off the fuel.
Note: Ask your customer service.
2. Remove the spark plug connector (05/1).
3. Place the container (07/1) for the old oil.
4. Unscrew the oil dipstick (07/2) and wipe it
clean.
5. Unscrew and remove the drain plug (07/3).
6. Allow the oil to run out completely into a con-
tainer.
22
7. Replace the drain plug. Ensure that the gas-
ket is correctly positioned. Tighten the drain
plug firmly.
8. Top-up clean oil through the dipstick opening.
Use a funnel (not included with the engine).
Note: The maximum oil capacity of the en-
gine is 1.2 litres.
9. Insert the dipstick up to the stop and then pull
out again. Check that the level has reached
the MAX (07/4) mark.
10. Insert oil dipstick and screw in tight.
11. Remove any spilled oil.
7.3

Clean engine and silencer (08)

IMPORTANT! Risk of fire due to foreign
objects. Flammable foreign matter on the engine
can ignite during operation and set the lawn trac-
tor on fire.
■
Remove combustible debris (e.g. grass,
leaves, grease) from the engine, especially
from the exhaust and cylinder area.
■
Check and clean the exhaust and cylinder ar-
ea regularly.
1. Allow the engine to cool before cleaning.
2. Remove the contamination regularly from the
engine with a cleaning cloth or brush. Im-
portant! Do not spray the engine with water.
Penetrating water (ignition system, carburet-
tor...) can lead to malfunctions.
3. Blow-off all waste and dirt residues from the
silencer and its cover using compressed air.
4. Clean the cooling system:
■
Remove obstructions from cooling air
openings (08/1).
■
In order to prevent overheating, also
clean the internal cooling vanes and sur-
faces.
5. Wipe plastic parts with a damp sponge (08/2)
and detergent.
7.4

Clean the air filter (09)

1. Clean the area around the filter cover.
2. Unscrew the two knobs (09/2) on the filter
cover (09/1).
3. Remove filter cover.
4. Remove filter element (09/3, 09/4).
5. Disconnect the foam pre-filter (09/4) from the
cartridge (09/3).
6. Close the intake manifold of the engine with a
cloth (09/5).
Maintenance and care
PRO 350 | PRO 450