Skil SS9503-00 Manual Del Propietário página 14

1. Table
Surface where the workpiece rests while
performing sawing operation. The table could
be tilted for bevel cutting.
2. Sawdust Collection Port
Allows you to attach a vacuum hose for easy
sawdust collection.
3. Power Switch
Used to power the saw ON and OFF.
4. Safety Key
It is a safety feature. The power switch
cannot be turned ON without the safety key
5. Power Indicator
Used to indicate if the saw is powered ON or
OFF.
6. Variable Speed Dial
Turn the dial to adjust the sawing speed.
7. Foot Pedal Control Switch
The switch determines if the saw can be
turned on by foot pedal, when the saw is
powered ON.
8. Base
Helps to minimize vibration of the saw.
9. Brush Cap
Allows you to open it to perform motor brush
maintenance.
10. Table Stop Screw
Limit the table position to prevent the
excessive tilt of the table.
11. Rubber Bearing Cover (x 4)
Protects the bearing from dust and allows
you to remove it for bearing lubrication.
12. Blade Tension Lever
Loosen or tighten the blade tension by pull
the lever up or pushing it down.
13. LED Light
Provides additional light during operation. It
can be positioned to direct the light to desired
spot.
14. Foot Pedal Storage
Allows you to store the foot pedal when it is
not in use.
15. Power Plug
Connects the saw to the power source.
14
16. Foot Pedal
Allows you to stop the scroll saw by stepping
on the pedal.
17. Blade Gauge
Helps to install the pinless (plain-end) blade
into blade adaptors.
18. Drop Foot Height Lock Knob
Allows you to raise or lower the drop foot and
lock it in place.
19. Storage Compartment
Provides storage for accessories.
20. Bevel Scale and Pointer
The bevel scale and pointer show you the
degree the saw table is tilted.
21. Bevel Lock Knob
Allows you to tilt the table and lock it at the
desired angle up to 45°.
22. Table Insert
Could be removed for blade removal and
installation.
23. Drop Foot
This foot should always be lowered until it
just rests on top of the workpiece to prevent
the workpiece from lifting, yet not so much
that the workpiece drags.
24. Pin-end Blade
A type of blade that features pins on both
ends.
25. Upper Blade Holder
Holds the upper end of the blade.
26. Sawdust Blower Lock Screw
Allows you to adjust the sawdust blower
and lock it at the desired spot for best
performance.
27. Drop Foot Bevel Lock Screw
Allows you to tilt the drop foot and lock it in
place.
28. Sawdust Blower
Keeps the line of cut on the workpiece
clean for more accurate scroll cuts. For best
results, always direct the airflow at the blade
and the workpiece.