Skil SS9503-00 Manual Del Propietário página 22

2. Carefully push up the table insert from under
the table and remove it from the table
(Fig. 15).
3. Push down the upper blade holder to remove
the blade from the upper and lower blade
holders (Fig. 16a or Fig. 16b).
4. To install pin-end blade, hook the blade
in the slot of the lower blade holder. While
pushing down on the upper blade holder,
insert the blade into the slot of the upper
blade holder.
To install plain-end blade, hook the blade
adaptor (included) onto the outer section of
the lower blade holder. While pushing down
on the upper blade holder, hook the top
blade adaptor onto the outer section of the
upper blade holder.
NOTE: The plain-end blade should be installed
with blade adaptors. Refer to the section "At-
taching blade adaptors to plain-end blade"
for instructions.
Fig. 16b
Front Cutting Side Cutting
Position Position
22
Blade Adaptor
Plain-end Blade
Fig. 15
Fig. 16a
Upper
Blade
Holder
Lower Blade
Holder
Table Insert
Pin-end
Blade
Front Cutting
Position
Side Cutting
Position
Lower Blade Holder