Skil SS9503-00 Manual Del Propietário página 19

Drop foot adjustment (Fig. 10)
When cutting at angles, the drop foot should be
adjusted so it is parallel to the table and rests
flat on top of the workpiece.
To adjust height
Loosen the lock knob, raise or lower the drop
foot until it just rests on top of the workpiece,
and then tighten the knob.
To adjust bevel
Required tool (not included): Philips head
screwdriver
Loosen the 'screw - locking washer - flat washer'
set, tilt the drop foot so it is parallel to the table,
and then tighten the screw.
Dust blower adjustment (Fig. 11)
Required tool (not included):
 Philips head screwdriver
Loosen the screw, adjust the dust blower, and
then tighten the M6 screw. For best results, the
dust blower tube should be adjusted to direct
air at both the blade and the workpiece.
Sawdust collection port
(Fig. 12 & Fig. 13)
This scroll saw features a dust collection port
that allows connection of a Ø1-1/2" (31.8 mm)
vacuum hose or adapter (not included).
If excessive sawdust buildup occurs inside
the base, detach the metal plate and remove
sawdust as below:
Required tool (not included):
 Philips head screwdriver
1. Open the storage compartment to expose
the M5 screw of the metal plate.
2. Loosen and remove two screws and metal
plate from the scroll saw.
3. Use a wet/dry vacuum cleaner or manually remove sawdust.
Fig. 10
'Screw - Locking Washer -
Flat Washer' Set
Fig. 11
Screw
Fig. 12
Sawdust Collection Port
Lock Knob
Drop Foot
Dust Blower
19