Skil SS9503-00 Manual Del Propietário página 24

6. Snap the table insert back into place
(Fig. 19a & Fig. 19b).
NOTE: The table insert should be mounted in
the way that the blade is allowed to go through
the slot of the table insert when beveling the
table.
Attaching blade adaptors to plain-end blade
 For front cutting
Required tool:
 2.5mm L wrench
a. Loosen the set screw just enough to
slide one adaptor onto each end of the
blade
(Fig. 20).
b. Place the blade and adaptors into the
blade gauge to set the blade to the
proper length, and securely tighten the
set screw.
24
Fig. 19a
Table Insert
Fig. 19b
Fig. 20
Set Screw
Adaptor
Pin
Pin-end
Blade
Slot
Plain-end
Blade
Plain-end
Blade
Blade Adaptors
in Blade Gauge