Skil SS9503-00 Manual Del Propietário página 20

4. Reattach the metal plate, tighten the screws
and close the storage compartment before
starting the saw.
Blade
WARNING
Blade Information
 Scroll saw blades wear out and must be replaced frequently for best cutting results.
Scroll saw blades generally stay sharp for 1/2 hour to 2 hours of cutting, depending on
type of material and speed of operation.
 When choosing a blade, carefully consider the follo
Very fine, narrow blades should be used to scroll cut in thin material – 1/4" (6 mm) or
•
less.
Most blade packages state the size or thickness and type of material which that blade
•
is intended to cut. The package should also state the radius or size of curve that can be
cut with that blade size.
Wider blades cannot cut curves as tight or as small as thinner blades.
•
 Blades wear faster when:
Cutting plywood, hardwood, and other laminates.
•
Cutting material thicker than 3/4" (19 mm).
•
Side pressure is applied to the blade.
•
20
To reduce the risk of injury always turn saw OFF and disconnect the
plug from the outlet before removing or replacing the blade.
Fig. 13
Metal Plate
Storage Compartment
(Open)
wing:
Screws & Washers