Publicidad
Idiomas disponibles
Idiomas disponibles
en
14
Mounting the sanding belt
(figure 3).
Position the sanding belt around the drive
roller and the deflection roller on the fixed
extension arm.
Push the swivelling extension arm inward
and position the sanding belt onto its deflec-
tion roller.
Firmly push the swivelling extension arm
outward to tension the sanding belt and
make it ready for operation.
Mount the protection guard again.
Tighten the fastening nuts on both sides.
Carry out a test run for approx. 20 seconds
with the new sanding belt.
Pay attention that the arrow directions
on the inside of the sanding belt and
the housing of the power tool correspond.
Fig. 3
Swivelling extension arm
Deflection roller
3.
Grinding belt
5.
SW 10
4.
Protection guard
5.
SW 10
Fastening nut
Publicidad
