92001i-EU 1900W RATED PORTAbLE INvERTER GENERATOR
Starting the Engine
1. Make certain the generator is on a flat, level surface.
2. Disconnect all electrical loads from the generator. Never
start or stop the generator with electrical devices plugged
in or turned on.
3. Turn the fuel cap vent lever to the "ON" position.
4. Turn the fuel dial clockwise to the full "ON" position.
5. Pull choke knob out to the "CHOKE" position.
6. Pull the recoil cord slowly until resistance is felt and then
pull rapidly.
7. As engine warms up, push the choke knob in to the "RUN"
position.
Keep choke lever in "CHOKE" position for only 1 pull of the
recoil cord. After first pull, press the choke knob in to the
"RUN" position for up to the next 3 pulls of the recoil cord.
Too much choke leads to spark plug fouling/engine flooding
due to the lack of incoming air. This will cause the engine
not to start.
For gasoline restarts with hot engine in hot ambient >
86°F (30°C): If generator does not start after the first pull,
press the choke knob in to the "RUN" position for the next
3 pulls. Too much choke leads to spark plug fouling/engine
flooding due to the lack of incoming air. This will cause the
engine not to start.
For gas starting in cold ambient < 59°F (15°C): The
choke must be in 100% of the "CHOKE" position for manual
start procedures. Do not over-choke. As soon as engine
starts, push the choke knob in the "RUN" position.
15
OPERATION
NOTICE
NOTICE
NOTICE
EN